1208 BigIron RX Series Configuration Guide53-1001986-01Displaying OSPFv3 information48Syntax: show ipv6 ospf area [<area-id>]You can specify the <area-id> parameter in the following formats:• As an IPv4 address, for example, 192.168.1.1• As a numerical value from 0 – 2,147,483,647The <area-id> parameter restricts the display to the specified OSPF areaThis display shows the following information.Displaying OSPFv3 database InformationYou can display a summary of the Brocade device’s link state database or detailed informationabout a specified LSA type.To display a summary of a device’s link state database, enter the following command at any CLIlevel.TABLE 207 OSPFv3 area information fieldsThis field... Displays...Area The area number.Interface attached to this area The router interfaces attached to the area.Number of Area scoped LSAs Number of LSAs with a scope of the specified area.SPF algorithm executed The number of times the OSPF Shortest Path First (SPF) algorithm is executedwithin the area.SPF last updated The interval in seconds that the SPF algorithm was last executed within thearea.Current SPF node count The current number of SPF nodes in the area.Router Number of router LSAs in the area.Network Number of network LSAs in the area.Indx The row number of the entry in the router’s OSPF area table.Area The area number.Maximum hop count to nodes. The maximum number of hop counts to an SPF node within the area.BigIron RX# show ipv6 ospf areaArea 0:Interface attached to this area: loopback 2 ethe 3/2 tunnel 2Number of Area scoped LSAs is 6Statistics of Area 0:SPF algorithm executed 16 timesSPF last updated: 335256 sec agoCurrent SPF node count: 3Router: 2 Network: 1Maximum of Hop count to nodes: 2...
