434 BigIron RX Series Configuration Guide53-1001986-01Displaying VSRP information15FIGURE 83 New path establishedThere are no CLI commands used to configure this process.Displaying VSRP informationYou can display the following VSRP information:• Configuration information and current parameter values for a VRID or VLAN• The interfaces on a VSRP-aware device that are active for the VRIDDisplaying VRID informationTo display detailed VSRP information, enter the show vsrp vrid or show vsrp vlan command. Bothcommands show the same information as in the following example.Syntax: show vsrp [vrid | vlan ]X XPath 1 Path 2MRPMemberMRPMasterMRPMemberMRPMemberMRPMRP MemberVSRP BackupVSRPHostMRP MemberVSRP MasterMRPMemberMRPMemberMRPMRP MasterVSRP BackupVSRPMRP MemberVSRP MasterDevice 1Device 1HostBigIron RX# show vsrp vrid 100VLAN 10Auth-type no authenticationVRID 10========State Administrative-status Advertise-backup Preempt-modeMaster Enabled Disabled TrueParameter Configured Current Unit/FormulaPriority 100 80 (100-0)*(4.0/5.0)Hello-interval 1 1 sec/10Dead-interval 3 3 sec/10Hold-interval 3 3 sec/10Initial-ttl 2 2 hopsBackup-Hello 60 60 sec/10Next hello sent in 00:00:01Member ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 11/1 ethe 14/1Operational ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1Forwarding ports: ethe 3/1 ethe 3/3 ethe 6/1 ethe 14/1Restart ports: 3/1(10) 3/3(10) 6/1(10) 11/1(10) 14/1(10)
