BigIron RX Series Configuration Guide 122153-1001986-01Displaying OSPFv3 information 48Syntax: show ipv6 ospf redistribute route [<ipv6-prefix>]The <ipv6-prefix> parameter specifies an IPv6 network prefix. (You do not need to specify thelength of the prefix.)For example, to display redistribution information for the prefix 2002::, enter the followingcommand at any level of the CLI.These displays show the following information.Displaying OSPFv3 route informationYou can display the entire OSPFv3 route table for the Brocade device or only the route entries for aspecified destination.To display the entire OSPFv3 route table for the device, enter the following command at any level ofthe CLI.TABLE 215 OSPFv3 redistribution informationThis Field... Displays...ID An ID for the redistributed route.Prefix The IPv6 routes redistributed into OSPFv3.Protocol The protocol from which the route is redistributed into OSPFv3. Redistributedprotocols can be the following:• BGP – BGP4+.• RIP – RIPng.• ISIS – IPv6 IS-IS.• Static – IPv6 static route table.• Connected – A directly connected network.Metric Type The metric type used for routes redistributed into OSPFv3. The metric type canbe the following:• Type-1 – Specifies a small metric (2 bytes).• Type-2 – Specifies a big metric (3 bytes).Metric The value of the default redistribution metric, which is the OSPF cost ofredistributing the route into OSPFv3.BigIron RX# show ipv6 ospf redistribute routeId Prefix Protocol Metric Type MetricsnIpAsPathAccessListStringRegExpression1 2002::/16 Static Type-2 12 2002:1234::/32 Static Type-2 1BigIron RX# show ipv6 ospf redistribute route 2002::Id Prefix Protocol Metric Type Metric1 2002::/16 Static Type-2 1
