710 BigIron RX Series Configuration Guide53-1001986-01Configuring OSPF25• virtual-interface-config-error-trap – [MIB object: ospfVirtIfConfigError]• interface-authentication-failure-trap – [MIB object: ospfIfAuthFailure]• virtual-interface-authentication-failure-trap – [MIB object: ospfVirtIfAuthFailure]• interface-receive-bad-packet-trap – [MIB object: ospfIfrxBadPacket]• virtual-interface-receive-bad-packet-trap – [MIB object: ospfVirtIfRxBadPacket]The following traps are disabled by default:• interface-retransmit-packet-trap – [MIB object: ospfTxRetransmit]• virtual-interface-retransmit-packet-trap – [MIB object: ospfVirtIfTxRetransmit]• originate-lsa-trap – [MIB object: ospfOriginateLsa]• originate-maxage-lsa-trap – [MIB object: ospfMaxAgeLsa]• link-state-database-overflow-trap – [MIB object: ospfLsdbOverflow]• link-state-database-approaching-overflow-trap – [MIB object: ospfLsdbApproachingOverflowTo stop an OSPF trap from being collected, use the CLI command: no trap , at theRouter OSPF level of the CLI. To disable reporting of the neighbor-state-change-trap, enter thefollowing command.BigIron RX(config-ospf-router)# no trap neighbor-state-change-traTo reinstate the trap, enter the following command.BigIron RX(config-ospf-router)# trap neighbor-state-change-trapSyntax: [no] snmp-server trap ospf Enabling OSPF loggingBy default, most OSPF logging is enabled (Refer to Table 109 on page 709 for a complete list of theOSPF default trap settings). If OSPF logging has been previously disabled, you must enable OSPFlogging if you want SNMP traps to be generated for OSPF. Enter commands such as the following.BigIron RX(config)#router ospfBigIron RX(config-ospf-router)#log allSyntax: log all | adjacency | bad_packet | database | memory | retransmitEnter all to log all OSPF traps generated.Enter adjacency to log only the traps for adjacency changesEnter bad_packet to log only those traps for bad packetsEnter memory to log only those traps related to memory issues.Enter retransmit to log only those traps related to retransmission activities.NOTEOSPF retransmit is not logged when log retransmit option is enabled.Modify OSPF standard compliance settingThe BigIron RX is configured, by default, to be compliant with the RFC 1583 OSPF V2 specification.
