320 BigIron RX Series Configuration Guide53-1001986-01Displaying VLAN information11Other configuration optionsYou can also configure the following on a VLAN:• “Configuring static ARP entries” on page 136• “Setting maximum frame size per PPCR” on page 178Displaying VLAN informationAfter you configure the VLANs, you can view and verify the configuration.Displaying VLAN informationEnter the following command at any CLI level.Syntax: show vlan [] [| [begin | exclude | include]Enter a VLAN ID if you want to display information for a specific VLAN.The output shows the following information.TABLE 67 Output of show vlanThis field... Displays...Configured PORT-VLAN entries Number of port-based VLANs in the configuration.Maximum PORT-VLAN entries: 4095 Maximum number of port-based VLANs that you can configure. Notehowever, IDs 4091 and 4092 are reserved for control purposes.Default PORT-VLAN id ID of the default VLAN.PORT-VLAN ID of the port-based VLANName Name of the port-based VLAN. [None] appears if a name has not beenassigned.Priority Level Priority level assigned to the port-based VLANL2 protocols Layer 2 control protocol configured on the VLANBigIron RX# show vlanConfigured PORT-VLAN entries: 3Maximum PORT-VLAN entries: 4095Default PORT-VLAN id: 1PORT-VLAN 1, Name DEFAULT-VLAN, Priority Level0L2 protocols : NONEUntagged Ports : ethe 2/1 to 2/24 ethe 3/1 to 3/24 ethPORT-VLAN 2, Name [None], Priority Level0L2 protocols : NONEip-protocol VLAN, Dynamic port disabledName: basicPORT-VLAN 1001, Name [None], Priority Level0L2 protocols : MRPTagged Ports : ethe 3/1 ethe 3/12 to 3/13 ethe 3/24
