BigIron RX Series Configuration Guide 61353-1001986-01Displaying PIM Sparse configuration information and statistics 23Displaying the RP set listTo display the RP set list, enter the following command at any CLI level.Syntax: show ip pim rp-setThis display shows the following information.Displaying multicast neighbor informationTo display information about the BigIron RX’s PIM neighbors, enter the following command at anyCLI level.This field... Displays...RP Indicates the IP address of the Rendezvous Point (RP) for the specifiedPIM Sparse group.Following the IP address is the port or virtual interface through whichthis BigIron RX learned the identity of the RP.Info source Indicates the IP address on which the RP information was received.Following the IP address is the method through which this BigIron RXlearned the identity of the RP.This field... Displays...Number of group prefixes The number of PIM Sparse group prefixes for which the RP isresponsible.Group prefix Indicates the multicast groups for which the RP listed by the previousfield is a candidate RP.RPs expected/received Indicates how many RPs were expected and received in the latestBootstrap message.RP Indicates the RP number. If there are multiple RPs in the PIM Sparsedomain, a line of information for each of them is listed, and they arenumbered in ascending numerical order.priority The RP priority of the candidate RP. During the election process, thecandidate RP with the highest priority is elected as the RP.age The age (in seconds) of this RP-set.NOTE: If this BigIron RX is not a BSR, this field contains zero. Only theBSR ages the RP-set.BigIron RX(config)#show ip pim rp-setGroup address Static-RP-address Override---------------------------------------------------Access-List 44 99.99.99.5 OnNumber of group prefixes Learnt from BSR: 1Group prefix = 239.255.162.0/24 # RPs expected: 1# RPs received: 1RP 1: 43.43.43.1 priority=0 age=0
