BigIron RX Series Configuration Guide 117353-1001986-01Displaying IPv6 MBGP information 46Displaying summary MBGP informationTo display summary MBGP information, enter the following command at any CLI prompt.Syntax: show ipv6 mbgp summaryNOTEThis command’s display looks similar to the display for the show ipv6 bgp config command.However, the show ipv6 mbgp config command lists only the MBGP neighbors, whereas the showipv6 bgp config command lists only the BGP neighbors.Displaying the Active MBGP ConfigurationTo display the active MBGP configuration information contained in the running-config withoutdisplaying the entire running-config, enter the following command at any level of the CLI.show ipv6 mbgp dampened-paths Displays IPv6 MBGP paths that have been dampened by route flapdampening.show ipv6 mbgp flap-statistics Displays route flap dampening statistics.show ipv6 mbgp filtered-routes Displays routes that have been filtered out.TABLE 205 IPv6 MBGP Show commands (Continued)Command DescriptionBigIron RX# show ipv6 mbgp summaryBGP4 SummaryRouter ID: 9.9.9.1 Local AS Number : 200Confederation Identifier : not configuredConfederation Peers:Maximum Number of Paths Supported for Load Sharing : 1Number of Neighbors Configured : 1, UP: 1Number of Routes Installed : 5677Number of Routes Advertising to All Neighbors : 5673Number of Attribute Entries Installed : 3Neighbor Address AS# State Time Rt:Accepted Filtered Sent ToSend166.1.1.2 200 ESTAB 0h24m54s 3 0 5673 0
