Task Command Syntax Command Mode10.1.1.1 (local)Hold Down: 0 sec, Preempt: TRUE,AdvInt: 1 secAdv rcvd: 0, Bad pkts rcvd: 0, Advsent: 43, Gratuitous ARP sent: 0Virtual MAC address:00:00:5e:00:01:0aVirtual IP address:10.1.1.100Authentication: (none)Configuring Management VRFYou can assign a management interface to a management VRF.1 Create a management VRF.CONFIGURATIONip vrf management2 Assign a management port to a management VRF.VRF MODEinterface managementWhen Management VRF is configured, the following interface range or interface group commands are disabled:• ipv6 nd dad — Duplicated Address Detection• ipv6 nd dns-server — Configure DNS distribution option in RA packets originated by the router• ipv6 nd hop-limit — Set hop limit advertised in RA and used in IPv6 data packets originated by the router• ipv6 nd managed-config-flag — Hosts should use DHCP for address config• ipv6 nd max-ra-interval — Set IPv6 Max Router Advertisement Interval• ipv6 nd mtu — Configure MTU advertisements in RA packets• ipv6 nd other-config-flag — Hosts should use DHCP for non-address config• ipv6 nd prefix — Configure IPv6 Routing Prefix Advertisement• ipv6 nd ra-guard — Configure IPv6 ra-guard• ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime• ipv6 nd reachable-time — Set advertised reachability time• ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA• ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements• ipv6 ad — IPv6 Address Detection• ipv6 ad autoconfig — IPv6 stateless auto-configuration• ipv6 address — Configure IPv6 address on an interfaceNOTE: The command line help still displays relevant details corresponding to each of these commands. However, these interfacerange or interface group commands are not supported when Management VRF is configured.Configuring a Static Route• Configure a static route that points to a management interface.CONFIGURATION1012 Virtual Routing and Forwarding (VRF)
