Field DescriptionLocal DCBx Status: Sequence Number Sequence number transmitted in Control TLVs.Local DCBx Status: Acknowledgment Number Acknowledgement number transmitted in Control TLVs.Local DCBx Status: Protocol State Current operational state of DCBx protocol: ACK or IN-SYNC.Peer DCBx Status: DCBx Operational Version DCBx version advertised in Control TLVs received from peer device.Peer DCBx Status: DCBx Max Version Supported Highest DCBx version supported in Control TLVs received frompeer device.Peer DCBx Status: Sequence Number Sequence number transmitted in Control TLVs received from peerdevice.Peer DCBx Status: Acknowledgment Number Acknowledgement number transmitted in Control TLVs receivedfrom peer device.Total DCBx Frames transmitted Number of DCBx frames sent from local port.Total DCBx Frames received Number of DCBx frames received from remote peer port.Total DCBx Frame errors Number of DCBx frames with errors received.Total DCBx Frames unrecognized Number of unrecognizable DCBx frames received.QoS dot1p Traffic Classification and QueueAssignmentThe following section describes QoS dot1P traffic classification and assignments.DCB supports PFC, ETS, and DCBx to handle converged Ethernet traffic that is assigned to an egress queue according to the followingQoS methods:Honor dot1p You can honor dot1p priorities in ingress traffic at the port or global switch level (refer to Default dot1p to QueueMapping) using the service-class dynamic dot1p command in INTERFACE configuration mode.Layer 2 class maps You can use dot1p priorities to classify traffic in a class map and apply a service policy to an ingress port to maptraffic to egress queues.NOTE: Dell Networking does not recommend mapping all ingress traffic to a single queue when using PFC and ETS. However,Dell Networking does recommend using Ingress traffic classification using the service-class dynamic dot1p command(honor dot1p) on all DCB-enabled interfaces. If you use L2 class maps to map dot1p priority traffic to egress queues, take intoaccount the default dot1p-queue assignments in the following table and the maximum number of two lossless queues supportedon a port (refer to Configuring Lossless Queues).Although Dell Networking OS allows you to change the default dot1p priority-queue assignments (refer to Setting dot1p Priorities forIncoming Traffic), DCB policies applied to an interface may become invalid if you reconfigure dot1p-queue mapping. If the configuredDCB policy remains valid, the change in the dot1p-queue assignment is allowed.Configuring the Dynamic Buffer MethodPriority-based flow control using dynamic buffer spaces is supported on the switch.To configure the dynamic buffer capability, perform the following steps:1 Enable the DCB application. By default, DCB is enabled and link-level flow control is disabled on all interfaces.CONFIGURATION mode282 Data Center Bridging (DCB)
