dot1x profile {profile-name}profile—name — Enter the dot1x profile name. The profile name length is limited to 32 characters.Example of Configuring and Displaying a dot1x ProfileDell(conf)#dot1x profile testDell(conf-dot1x-profile)#Dell#show dot1x profile802.1x profile information-----------------------------Dot1x Profile testProfile MACs00:00:00:00:01:11Configuring MAC addresses for a do1x ProfileTo configure a list of MAC addresses for a dot1x profile, use the mac command. You can configure 1 to 6 MAC addresses.• Configure a list of MAC addresses for a dot1x profile.DOT1X PROFILE CONFIG (conf-dot1x-profile)mac mac-addressmac-address — Enter the keyword mac and type up to the 48– bit MAC addresses using the nn:nn:nn:nn:nn:nn format. A maximumof 6 MAC addresses are allowed.Example of Configuring a List of MAC Addresses for a dot1x ProfileThe following example configures 2 MAC addresses and then displays these addresses.Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:01:11Dell(conf-dot1x-profile)#show configdot1x profile samplemac 00:50:56:aa:01:10mac 00:50:56:aa:01:11Dell(conf-dot1x-profile)#Dell(conf-dot1x-profile)#exitDell(conf)#Configuring the Static MAB and MAB ProfileEnable MAB (mac-auth-bypass) before using the dot1x static-mab command to enable static mab.To enable static MAB and configure a static MAB profile, use the following commands.• Configure static MAB and static MAB profile on dot1x interface.INTERFACE modedot1x static-mab profile profile-nameEenter a name to configure the static MAB profile name. The profile name length is limited to a maximum of 32 characters.Example of Static MAB and MAB Profile for an InterfaceDell(conf-if-Te-2/1)#dot1x static-mab profile sampleDell(conf-if-Te 2/1))#show config!interface TenGigabitEthernet 21switchportdot1x static-mab profile sampleno shutdown90 802.1X
