The range is from 1 to 64.2 Add interfaces to the ECMP group bundle.CONFIGURATION ECMP-GROUP modeinterface interface3 Enable monitoring for the bundle.CONFIGURATION ECMP-GROUP modelink-bundle-monitor enableModifying the ECMP Group ThresholdYou can customize the threshold percentage for monitoring ECMP group bundles.To customize the ECMP group bundle threshold and to view the changes, use the following commands.• Modify the threshold for monitoring ECMP group bundles.CONFIGURATION modelink-bundle-distribution trigger-threshold {percent}The range is from 1 to 90%.The default is 60%.• Display details for an ECMP group bundle.EXEC modeshow link-bundle-distribution ecmp-group ecmp-group-idThe range is from 1 to 64.Viewing an ECMP GroupNOTE: An ecmp-group index is generated automatically for each unique ecmp-group when you configure multipath routes to thesame network. The system can generate a maximum of 512 unique ecmp-groups. The ecmp-group indices are generated in evennumbers (0, 2, 4, 6... 1022) and are for information only.You can configure ecmp-group with id 2 for link bundle monitoring. This ecmp-group is different from the ecmp-group index 2 that iscreated by configuring routes and is automatically generated. These two ecmp-groups are not related in any way.Dell(conf-ecmp-group-5)#show config!ecmp-group 5interface tengigabitethernet 1/1/2/1interface tengigabitethernet 1/1/2/2link-bundle-monitor enableDell(conf-ecmp-group-5)#Support for /128 IPv6 and /32 IPv4 Prefixes in Layer 3 HostTable and LPM TableIPv6 enhancements utilize the capability on platform to program /128 IPv6 prefixes in LPM table and /32 IPv4 prefixes in Host table. Alsohost table provides ECMP support for destination prefixes in the hardware. The platform uses the hardware chip that supports thisbehavior and hence they can make use of this capability.CLI commands are introduced to move /128 IPv6 prefix route entries and /32 IPv4 prefix route entries from Host table to LPM table andvice versa. When moving the destination prefixes from Route to Host table, there is a possibility of getting into hash collision because the308 Equal Cost Multi-Path (ECMP)
