• dot1p vlan-priority-value: specifies the virtual local area network (VLAN) priority tag assigned to incoming packets in aniSCSI session. The range is from 0 to 7. The default is: the dot1p value in ingress iSCSI frames is not changed and the same priorityis used in iSCSI TLV advertisements if you do not enter the iscsi priority-bits command (Step 10).• dscp dscp-value: specifies the DSCP value assigned to incoming packets in an iSCSI session. The range is from 0 to 63. Thedefault is: the DSCP value in ingress packets is not changed.• remark: marks incoming iSCSI packets with the configured dot1p or DSCP value when they egress the switch. The default is: thedot1 and DSCP values in egress packets are not changed.8 (Optional) Set the aging time for iSCSI session monitoring.CONFIGURATION mode[no] iscsi aging time time.The range is from 5 to 43,200 minutes.The default is 10 minutes.9 (Optional) Configures DCBX to send iSCSI TLV advertisements.LLDP CONFIGURATION mode or INTERFACE LLDP CONFIGURATION mode[no] advertise dcbx-app-tlv iscsi.You can send iSCSI TLVs either globally or on a specified interface. The interface configuration takes priority over global configuration.The default is Enabled.10 (Optional) Configures the advertised priority bitmap in iSCSI application TLVs.LLDP CONFIGURATION mode[no] iscsi priority-bits.The default is 4 (0x10 in the bitmap).11 (Optional) Configures the auto-detection of Compellent arrays on a port.INTERFACE mode[no] iscsi profile-compellent.The default is: Compellent disk arrays are not detected.Displaying iSCSI Optimization InformationTo display information on iSCSI optimization, use the following show commands.• Display the currently configured iSCSI settings.show iscsi• Display information on active iSCSI sessions on the switch.show iscsi sessions• Display detailed information on active iSCSI sessions on the switch . To display detailed information on specified iSCSI session, enter thesession’s iSCSI ID.show iscsi sessions detailed [session isid]• Display all globally configured non-default iSCSI settings in the current Dell Networking OS session.show run iscsiExamples of the show iscsi CommandsThe following example shows the show iscsi command.Dell#show iscsiiSCSI is enablediSCSI session monitoring is disabled456 iSCSI Optimization
