• You must apply the CAM-ACL space for the FCoE region before enabling the FIP-Snooping feature. If you do not apply CAM-ACLspace, the following error message is displayed:Dell(conf)#feature fip-snooping% Error: Cannot enable fip snooping. CAM Region not allocated for Fcoe.Dell(conf)#NOTE: Manually add the CAM-ACL space to the FCoE region as it is not applied by default.To support FIP-Snooping and set CAM-ACL, usecam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos 2 l2qos 0 l2pt 0ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.CAM ACL Table-- Chassis Cam ACL --Current Settings(in block sizes)1 block = 256 entriesL2Acl : 2Ipv4Acl : 0Ipv6Acl : 0Ipv4Qos : 2L2Qos : 0L2PT : 0IpMacAcl : 0VmanQos : 0EtsAcl : 1FcoeAcl : 2iscsiOptAcl : 2ipv4pbr : 0vrfv4Acl : 0Openflow : 0fedgovacl : 0nlbclusteracl: 0-- stack-unit 1 --Current Settings(in block sizes)1 block = 256 entriesL2Acl : 2Ipv4Acl : 0Ipv6Acl : 0Ipv4Qos : 2L2Qos : 0L2PT : 0IpMacAcl : 0VmanQos : 0EtsAcl : 1FcoeAcl : 2iscsiOptAcl : 2ipv4pbr : 0vrfv4Acl : 0Openflow : 0fedgovacl : 0nlbclusteracl: 0Dell(conf)#Enabling the FCoE Transit FeatureThe following sections describe how to enable FCoE transit.NOTE: FCoE transit is disabled by default. To enable this feature, you must follow the Configure FIPSnooping.As soon as you enable the FCoE transit feature on a switch-bridge, existing VLAN-specific and FIP snooping configurations are applied.The FCoE database is populated when the switch connects to a converged network adapter (CNA) or FCF port and compatible DCBFIP Snooping 319
