Dell(conf-router_bgp)#sho conf!router bgp 100neighbor 172.30.1.250 local-as 65057Dell(conf-router_bgp)#do show ip bgpBGP table version is 28093, local router ID is 172.30.1.57AS Number MigrationWith this feature you can transparently change the AS number of an entire BGP network and ensure that the routes are propagatedthroughout the network while the migration is in progress.When migrating one AS to another, perhaps combining ASs, an eBGP network may lose its routing to an iBGP if the ASN changes.Migration can be difficult as all the iBGP and eBGP peers of the migrating network must be updated to maintain network reachability.Essentially, Local-AS provides a capability to the BGP speaker to operate as if it belongs to "virtual" AS network besides its physical ASnetwork.The following illustration shows a scenario where Router A, Router B, and Router C belong to AS 100, 200, and 300, respectively. Router Aacquired Router B; Router B has Router C as its customer. When Router B is migrating to Router A, it must maintain the connection withRouter C without immediately updating Router C’s configuration. Local-AS allows this behavior to happen by allowing Router B to appear asif it still belongs to Router B’s old network (AS 200) as far as communicating with Router C is concerned.Figure 26. Before and After AS Number Migration with Local-AS EnabledWhen you complete your migration, and you have reconfigured your network with the new information, disable this feature.If you use the “no prepend” option, the Local-AS does not prepend to the updates received from the eBGP peer. If you do not select “noprepend” (the default), the Local-AS is added to the first AS segment in the AS-PATH. If an inbound route-map is used to prepend the as-path to the update from the peer, the Local-AS is added first. For example, consider the topology described in the previous illustration. IfRouter B has an inbound route-map applied on Router C to prepend "65001 65002" to the as-path, the following events take place onRouter B:1 Receive and validate the update.2 Prepend local-as 200 to as-path.Border Gateway Protocol IPv4 (BGPv4) 185
