Output (S,G) filter: none[Router 1]R1(conf)#do show ip msdp peerPeer Addr: 192.168.0.3Local Addr: 0.0.0.0(0) Connect Source: Lo 0State: Inactive Up/Down Time: 00:00:03Timers: KeepAlive 30 sec, Hold time 75 secSourceActive packet count (in/out): 0/0SAs learned from this peer: 0SA Filtering:Clearing Peer StatisticsTo clear the peer statistics, use the following command.• Reset the TCP connection to the peer and clear all peer statistics.CONFIGURATION modeclear ip msdp peer peer-addressExample of the clear ip msdp peer Command and Verifying Statistics are ClearedR3(conf)#do show ip msdp peerPeer Addr: 192.168.0.1Local Addr: 192.168.0.3(639) Connect Source: Lo 0State: Established Up/Down Time: 00:04:26Timers: KeepAlive 30 sec, Hold time 75 secSourceActive packet count (in/out): 5/0SAs learned from this peer: 0SA Filtering:Input (S,G) filter: myremotefilterOutput (S,G) filter: noneR3(conf)#do clear ip msdp peer 192.168.0.1R3(conf)#do show ip msdp peerPeer Addr: 192.168.0.1Local Addr: 0.0.0.0(0) Connect Source: Lo 0State: Inactive Up/Down Time: 00:00:04Timers: KeepAlive 30 sec, Hold time 75 secSourceActive packet count (in/out): 0/0SAs learned from this peer: 0SA Filtering:Input (S,G) filter: myremotefilterOutput (S,G) filter: noneDebugging MSDPTo debug MSDP, use the following command.• Display the information exchanged between peers.CONFIGURATION modedebug ip msdpExample of the debug ip msdp CommandR1(conf)#do debug ip msdpAll MSDP debugging has been turned onR1(conf)#03:16:08 : MSDP-0: Peer 192.168.0.3, sent Keepalive msg03:16:09 : MSDP-0: Peer 192.168.0.3, rcvd Keepalive msg03:16:27 : MSDP-0: Peer 192.168.0.3, sent Source Active msg03:16:38 : MSDP-0: Peer 192.168.0.3, sent Keepalive msg03:16:39 : MSDP-0: Peer 192.168.0.3, rcvd Keepalive msg03:17:09 : MSDP-0: Peer 192.168.0.3, sent Keepalive msgMulticast Source Discovery Protocol (MSDP) 549
