Example of Configuring the Minimum Oper Up Links in a Port ChannelDell#config tDell(conf)#int po 1Dell(conf-if-po-1)#minimum-links 5Dell(conf-if-po-1)#Adding or Removing a Port Channel from a VLANAs with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to a VLAN, place the port channel inLayer 2 mode (by using the switchport command).To add or remove a VLAN port channel and to view VLAN port channel members, use the following commands.• Add the port channel to the VLAN as a tagged interface.INTERFACE VLAN modetagged port-channel id numberAn interface with tagging enabled can belong to multiple VLANs.• Add the port channel to the VLAN as an untagged interface.INTERFACE VLAN modeuntagged port-channel id numberAn interface without tagging enabled can belong to only one VLAN.• Remove the port channel with tagging enabled from the VLAN.INTERFACE VLAN modeno tagged port-channel id numberorno untagged port-channel id number• Identify which port channels are members of VLANs.EXEC Privilege modeshow vlanConfiguring VLAN Tags for Member InterfacesTo configure and verify VLAN tags for individual members of a port channel, perform the following:1 Configure VLAN membership on individual portsINTERFACE modeDell(conf-if)#vlan tagged 2,3-42 Use the switchport command in INTERFACE mode to enable Layer 2 data transmissions through an individual interfaceINTERFACE modeDell(conf-if)#switchport3 Verify the manually configured VLAN membership (show interfaces switchport interface command).Interfaces 389
