The following output shows that Dell-1 forms OSPF neighborship with Dell-2.Dell-2#sh ip ospf neiNeighbor ID Pri State Dead Time Address Interface Area4.4.4.4 1 FULL/ - 00:00:33 10.10.100.1 Vl 100 0Dell-3 VLT Configurationvlt domain 110peer-link port-channel 110back-up destination 10.1.1.1primary-priority 4096system-mac mac-address 02:01:e8:d8:93:02unit-id 0peer-routing! proxy-gateway staticremote-mac-address 00:01:e8:d8:93:07remote-mac-address 00:01:e8:d8:93:e5These MAC addresses are the system L2 interface addresses for each switch at the remote site, Dell-1 and Dell-2.interface TenGigabitEthernet 0/8description "To Dell-1 10Gb"no ip addressinterface TenGigabitEthernet 0/9description "To Dell-1 10Gb"no ip address!port-channel-protocol LACPport-channel 50 mode activeno shutdown!interface Port-channel 50description "mVLT port channel to Dell-1"no ip addressswitchport no spanning-tree(STP is disabled between sites)vlt-peer-lag port-channel 50no shutdowninterface Vlan 101description ospf peering vlan across VLTPG_Po50ip address 10.10.101.2/30tagged Port-channel 50ip ospf network point-to-pointno shutdown!interface Vlan 102description ospf peering vlan to DELL-4ip address 10.10.102.1/30ip ospf network point-to-pointno shutdownThe following is the OSPF configuration on Dell-3.router ospf 1router-id 3.3.3.3network 10.10.101.0/30 area 0network 10.10.102.0/30 area 0992 VLT Proxy Gateway
