889 GENERATOR PROTECTION SYSTEM – INSTRUCTION MANUAL 3–1889 Generator Protection SystemChapter 3: InterfacesGEGrid SolutionsInterfacesThere are two methods of interfacing with the 889.• Interfacing via the relay keypad and display.• Interfacing via the EnerVista 8 Series Setup software.This section provides an overview of the interfacing methods available with the 889 usingthe relay control panel and EnerVista 8 Series Setup software. For additional details oninterface parameters (for example, settings, actual values, etc.), refer to the individualchapters.FIRST ACCESSING THE RELAYWhen first accessing the relay, log in as Administrator either through the front panel orthrough EnerVista connected serially (so that no IP address is required). Use the defaultpassword (the default password is “0”).Basic SecurityIf the relay is in the commissioning phase and you want to bypass authentication, switchthe “Setpoint access” setting on or assign it to a contact input. Once the setting is on, youhave complete administrator access from the front panel. If a contact input is chosen, theaccess is also conditional on the activation of the respective contact input.For more information on setpoint access and other security features available with basicsecurity, refer to the Basic Security section in the Setpoints chapter.CyberSentryIf logging in through EnerVista, choose Device authentication and login as Administrator.Note: If the relay is in the commissioning phase and the user wants to bypassauthentication, the user may use the setpoint access feature to gain administrative accessto the front panel in the same way as with basic security (see the “Basic Security” section).For more information on security features available with CyberSentry, refer to theCyberSentry security section in the Setpoints chapter.
