2019 Malibu Boats, LLC Owner’s Manual • Page 88Pull TypeTouch the Pull Type Off(which means it is currentlynot operating) to turn thisfeature on, and the followingscreen will appear:No two skiers are alike.Therefore the pull types exist to customize the ride to the skier.Keep in mind the concepts of Pull and Release. As you beginyour pull, the boat speed begins to drop below the set/target speed.As you let up on your pull, the boat speed begins to rise higher thanthe set/target speed. The letter tells the engine how quickly to beginthe apply or reduce power to get back to the set speed. The lowerthe letter (A being the lowest) the longer it will take for the engine torespond to the speed drop. The higher the letter (C being the highest)the faster the engine will respond to the speed drop.Choose the appropriate type based on the following criteria:Category A—This provides a slower engine response out of thebuoy, but the boat will tend to move ahead as the skier approachesthe buoy.Category B—This provides a moderate engine responsecompared to A and C.Category C—This provides a faster engine response out of thebuoy, but the boat will tend to hold back as the skier approaches thebuoy.The numbers decide how strong the pull of the boat will be felt bythe skier.Setting 1—This requires the lowest amount of load before thesystem initiates an RPM spread, and provides for a softer pull behindthe boat.Setting 2—This provides for a moderate pull behind the boat ascompared to 1 and 3.Setting 3—this requires the highest amount of load before thesystem initiates an RPM spread.Plus (+) FactorFor each letter setting, the + provides fasterengine response. This will benefit skiers looking forimmediate react from the engine/throttle.NOTE: The engine will respond quicker on A+than on C.Touch the + Factor to turn On and Off.Troubleshooting GuideDisplay appears not to work or doesn’t come on.1. Display could be in SLEEP mode. Touch a key on thekeypad to activate the display.2. Check for loose connections at the battery and display unit.3. Check for reversed polarity on the power connections.4. Verify the battery has a minimum voltage of six (6) volts.Display resets or goes OFF when starting the engine.1. Check that the display supply wires are connected properlyto the battery.2. Verify that the battery is charged properly.3. Check the battery for efficient starter current.Display has no backlight.1. Contact your authorized Malibu dealer for assistance.https://www.boat-manuals.com/
