1 = Surf Gate mounts 2 = Swimboard mounts3 = Underwater lights 4 = Surf pipe exhaust5 = Power Wedge 6 = Rudder7 = Propeller 8 = Strut9 = Driveshaft 10 = Water inlets11 = Rear plugOther Components Requiring Extra Attention (not pictured):• Any metal seacocks or ball valves• Any stainless steel or aluminum screws• Stainless steel hose clamps• Gas shocks• Hinges• Tracking fins• Buss bars• Power terminals• Helm seat slides• Starter• Engine mounts• Alternator• Transmission coupler• Bimini metal moving parts• Trailer swing-tongue pin• Underside of trailer• Trailer tongue assemblyExamine the sacrificial zinc anodes. Your authorized Malibudealer can offer guidance regarding the appropriate reduction rate,as well as the time at which anodes need to be replaced. Please notethat because this is a natural function of operating in certain bodiesof water, the cost of replacement is not covered under warranty.Flushing the EngineFlushing the engine is critical if the operating body of water wasnot clean. NOTE: In order to avoid drawing raw water in addition tocity water, you will need to close the raw water intake ball valve.The flush kit’s location is adjacent to the sea strainer. The seastrainer requires frequent maintenance by the consumer; however,the flush kit should not require any consumer maintenance.Boat owners and/oroperators should never makeany adjustments or attemptany maintenance to the flushkit; doing so may void the warranty.With the boat out of the water:• Locate the flush kit connector on the port side of the transom,above the swim platform.• Connect a gardening-type hose to the flush kit system at theconnector, and turn on the fresh water at the source.• With the boat shifter in neutral, start the engine and allow it toidle. During the entire process, DO NOT EXCEED 1100 RPM onthe engine. (The freshwater hose cannot provide sufficient watersupply to adequately cool the engine at higher RPMs.) Also, nevertake the boat out of neutral gear.• After approximately two (2) to three (3) minutes of flushing, shutoff the engine.• Turn off the freshwater supply.• Disconnect the hose and reinstall the cap on the flush kitconnector.After 10 Hours on the Hourmeter2019 Malibu Boats, LLC Owner’s Manual • Page 184Have the Engine Oil Changedby an Authorized Malibu MonsoonDealer1234 5 6 789 1011Do not do your first oil change before 10 hours or later than15 hours.The boat must be returned to authorized Malibu dealer for thehttps://www.boat-manuals.com/
