5-52Setup of System OperationThe following properties can be set as the operation setup of the whole system. Quick dumpIf this property is enabled (by checking "Enable" on the setup screen), the dump isacquired in parallel with the system startup if a fault occurs in the system. If this propertyis disabled, the dump is acquired by the dump function normally provided by OS.The initial setup value is "Enable." This value cannot be changed. Auto firmware updateIf a new CPU module containing BIOS different from that of the existing CPU module inversion with this property being enabled (by checking "Enable" on the setup screen), theBIOS of the new CPU module is updated to the BIOS of the existing CPU module tomatch with each other. If this property is disabled, the BIOS of the new CPU module isnot update automatically.The initial setup value is "Enable." Auto module startIf this property is enabled (by checking "Enable" on the setup screen), the CPU or PCImodule newly inserted is automatically started to be operable. If this property is disabled,the module is not started automatically.The initial setup value is "Enable."The system operation can be set on [FTServer] tree→[General] screen of the ft server utility.The table below shows the potential cases in which the system operation setup is changed. Contactyour maintenance personnel for the change of the system operation setup. Setting change will takeeffect after system reboot. However, the utility does not indicate that reboot is required.Quick dump Auto firmware update Auto module startComponent Remote Local Remote Local Remote LocalWholesystem–Executable ifthe system isoperating.When dump isacquired byusing the dumpfunctionnormallyinstalled in OSat occurrence ofsystem fault.–Executable if thesystem isoperating.When firmware isupdated manuallyat insertion ofnew CPU module–Executable if thesystem isoperating.When firmware isupdated manuallyat insertion of newCPU/PCI moduleRemote: Executable from remote management PC by using NEC ESMPRO ManagerLocal: Executable on local server by using ft server utility–: Not support
