4-11AdvancedSelect "Advanced" on the Advanced menu to display the following screen.See the table below for setup options on the screen.Option Parameter Description Your SettingBoot-timeDiagnostic Screen[Disabled]EnabledSpecify whether to display the Power OnSelf-Test (POST) screen at start-up. If"Disabled" is selected, the NEC logoappears while POST is in progress. (Todisplay POST check results, press Esc.)If "RomPilot Support" is set to "Enabled" or"Console Redirection" is set, this option isunconditionally set to "Enabled".RomPilot Support [Disabled]EnabledEnable or disable the RomPilot (the remoteconsole and remote drive features duringOS start-up). If this option is set to"Enabled", "Boot-time Diagnostic Screen" isunconditionally set to "Enabled".Post Error Pause [Enabled]DisabledSpecify whether to stop POST at the end ofPOST when an error occurs during POST.[ ]: Factory-setTIPS: "RomPilot" is a BIOS feature for communications with the NEC ManagementWorkstation Application (NEC MWA). To use the NEC MWA for management of the server,select "Enabled" for "RomPilot Support.” Use of the RomPilot features requires setups forthe NEC MWA.Select ItemSelect MenuBoot-time Diagnostic Screen:RomPilot Support:POST Error Pause:Display the diagnosticscreen during POSTinstead of the Logo.The boot-time diagnosticscreen is redirectionor rompilot is enabled.Item Specific HelpAdvanced[Disabled][Disabled][Enabled]Phoenix BIOS Setup UtilityAdvancedF1 Help -/+ Change Values F9 Setup DefaultsF10 Save Changes & ExitSub-MenuEnter SelectEsc ExitSelect ItemSelect Menu
