4-32 Configuring Your WorkstationOperating Procedures for LSI Software RAID Configuration UtilityCreating/Adding ConfigurationRun LSI Software RAID Configuration UtilityCreate configuration information (pack/virtual drive settings)Check the virtual drive settingsInitialize virtual drivePerform Consistency CheckExit LSI Software RAID Configuration Utility1. Run LSI Software RAID Configuration Utility.2. Select [Configure] → [New Configuration] from the TOP menu.Select [View/add Configuration] to add configuration.IMPORTANT: Creating a configuration using [New Configuration] menu clears theexisting configuration information. To add configurationinformation to the existing configuration, select [View/AddConfiguration]. You cannot create Spanning of RAID1, or set the virtual drivecapacity on [Easy Configuration] menu.Use [New Configuration] or [View/Add Configuration] instead. [Perform Consistency Check] is not required for RAID0.