Maintenance 7-9MAINTENANCE TOOLSThe Maintenance Tools is a tool of this product prevention to maintain, and to analyze the trouble.IMPORTANT: This guide contains procedures to use a floppy disk,however, your workstation is not equipped with factory-installed floppydisk drive. Use the optional Flash FDD or USB FDD.Starting Maintenance ToolsThe Maintenance Tools is started according to the following procedure.1. Turn on peripheral devices and the workstation in this order.2. Insert the NEC EXPRESSBUILDER DVD supplied with your workstation into the opticaldisk drive of your workstation.3. Press Ctrl, Alt, and Delete to reboot the workstation from the NEC EXPRESSBUILDER.(You may also turn off and then on again to reboot the workstation.)System boots up displaying Boot selection menu.IMPORTANT: An initial selection of the menu is "Os installation"."Os installation" starts by the automatic after the Boot selection menu isdisplayed.