4-46 Configuring Your WorkstationCONFIGURING MOTHER BOARD JUMPERSTo clear the CMOS data, use the jumper switch on the mother board of the workstation.IMPORTANT: Clearing the CMOS data resumes the factory-set configuration data. Do not change any other switch settings. Any change may cause theworkstation to fail or malfunction.WARNINGObserve the following instructions to use the workstation safely. Failure tofollow these instructions may result in death or serious personal injury. Seepages 1-3 to 1-10 for details.■ Do not disassemble, repair, or alter the workstation.■ Do not remove the lithium battery.■ Disconnect the power plug before working with the workstation.■ Do not connect any grounding line with the power cord of the workstationplugged to a power source.CAUTIONObserve the following instructions to use the workstation safely. Failure tofollow these instructions may cause a fire, personal injury, or propertydamage. See pages 1-3 to 1-10 for details.■ Make sure to complete device installation.■ Do not install the workstation on a rack with leaving covers removed.■ Do not drop the workstation.■ Do not pinch your finger with mechanical components.■ Avoid installation in extreme temperature conditions.IMPORTANT: The internal components are electronic componentseasily affected by static electricity. Before handling them, dischargestatic electricity from your body by touching the metal frame of theworkstation or the like. Do not touch the internal components andterminals of the boards with your bare hands. See "Static Precautions"in Chapter 9 for details on static electricity.