4-2 Configuring Your WorkstationSYSTEM BIOS ~ SETUP ~The SETUP utility is provided to make basic hardware configuration for the workstation. Thisutility is pre-installed in the flash memory of the workstation and ready to run.The workstation is configured with the correct parameters using the SETUP utility and shipped inthe best conditions. Thus, you don't need to use the SETUP utility in most cases. However, youmight wish to use the SETUP utility in the cases described below.IMPORTANT: The SETUP utility is intended for system administrator use only. The SETUP utility allows you to set a password. The workstation isprovided with two levels of password: Supervisor and User. Withthe Supervisor password, you can view and change all systemparameters of the SETUP utility. With the User password, systemparameters available for viewing and changing are limited. Do not set any password before installing the OS (operatingsystem). The workstation contains the latest version of the SETUP utility.Dialog boxes appear on your SETUP utility, thus, may differ fromdescriptions in this manual. If you find anything unclear, see theonline help or ask your sales representative. The workstation does not require BIOS parameter to select the OS.Setting of Plug-and-Play feature is not required.