236 Install and configure IP Trunk 3.01 (and later) nodeThe IP trunk cards must be enabled later after the card properties andoptionally, the IP Trunk 3.01 (and later) software, has been transmitted fromTM 3.1 to the IP trunk cards.Configure IP Trunk 3.01 (and later) data in TM 3.1Before the IP Trunk 3.01 (and later) data is configured in TM 3.1, obtainall the IP addresses for the new IP Trunk 3.01 (and later) node from thenetwork administrator and add them to the installation summary sheet. Usean IP Trunk 3.01 (and later) Installation Summary Sheet to facilitate dataentry into TM 3.1 (and later). Obtain the node IP addresses of any existingIP Trunk 3.01 (and later) nodes in the network.Refer to "ITG engineering guidelines" (page 87) for information on IP Trunk3.01 (and later) IP address requirements.An IP Trunk 3.01 (and later) node is a collection of Media Card 32-port andITG-Pentium 24-port trunk cards in a Meridian 1/CS 1000M system for aselected customer. Each node in the IP Trunk 3.01 (and later) network hasa property sheet that configures the options that apply to the node’s IPtrunk cards.TM 3.1 stores the Node Properties data. This data generates the BOOTP.1file. The data is transmitted to the Active Leader.The bootptab file is a configuration file that downloads to the Active Leadercard. It contains the list of cards and related IP and MAC addresses for thenode. Bootptab is short for "bootp table". When transmitted to the IP Trunk3.01 (and later) Active Leader IP trunk card, it is renamed "BOOTP.1".Add an IP Trunk 3.01 (and later) node in TM 3.1 manuallyThis section uses the TM 3.1 ITG ISDN IP Trunk application to manuallyadd and configure an IP Trunk 3.01 (and later) node and add IP trunk cardsto the node. A network of multiple IP Trunk 3.01 (and later) nodes can beconfigured and managed from the same TM 3.1 PC. Every IP Trunk 3.01(and later) node must first be added manually on the TM 3.1 PC and the TM3.1 IP Trunk 3.01 (and later) configuration data must be transmitted to theIP Trunk 3.01 (and later) node during installation.After adding a new IP Trunk 3.01 (and later) node on the TM 3.1 PC,the dialing plans for all existing IP Trunk 3.01 (and later) nodes must bemanually updated to include the destination node dial plan digits entries forthe new IP Trunk 3.01 (and later) node.There are several tabs across the top of the ITG Node Properties window.The following sections describe the windows that appear when each ofthese tabs is clicked.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.
