Install the DCHIP hardware upgrade kit 4774 Connect the NTCW84EA pigtail cable from port 0 of the DCHIP PCCard to the J14 pin header on the motherboard of the DCHIP card(see Figure 34 "DCHIP PC Card and NTCW84EA pigtail cable" (page192)). The cable routes the D-Channel signals to the backplane andthe I/O panel. The PC Card connector is keyed to allow insertiononly in the correct direction. The J14 pin header connector is notkeyed. Be careful to align the connector with the pin header.Figure 156DCHIP PC Card and NTCW84EA pigtail cable5 Pull the top and bottom locking devices away from the trunk cardfaceplate. Insert the trunk card into the card slots and carefullypush it until it makes contact with the backplane connector. Hookthe locking devices.—End—Install the DCHIP I/O Panel breakout cable from the upgrade kitThe breakout cable provides one D-channel connector.If installing the DCHIP upgrade kit for the NTCW80AA ITG 8-port trunk card,use the NTCW84MA I/O Panel breakout cable.If installing the DCHIP upgrade kit for the NTCW80CA ITG 8-port trunkcard, use the NTCW84LA I/O Panel breakout cable.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.