266 Install and configure IP Trunk 3.01 (and later) nodeVerify installation and configurationTo verify installation and configuration, check the IP trunk card faceplatedisplays.After successfully rebooting, the Leader 0 card is now fully configured withthe Node Properties of the node and enters a state of "Active Leader". Thefaceplate display shows "LDR".The Leader 1 card is now autoconfigured as a Leader, reboots automatically,and enters the state of "Backup Leader". The faceplate display shows"BLDR".Any Follower cards are now auto-configured with their IP addresses andtheir display shows "FLR".If an TM 3.1 PC is on the local ELAN subnet, it should now be incommunication with all cards in the IP Trunk 3.01 (and later) node.Observe IP Trunk 3.01 (and later) status in TM 3.1Follow the steps in Procedure 30 "Observing the IP Trunk 3.01 (and later)status in TM 3.1" (page 266) to observe the IP Trunk 3.01 (and later) statusin TM 3.1.Procedure 30Observing the IP Trunk 3.01 (and later) status in TM 3.1Step Action1 From the TM 3.1 IP Telephony Gateway - ISDN IP Trunk window,select menu View > Refresh and verify that the card status isshowing "enabled" or "disabled", depending on the card status in thesystem. See Figure 61 "IP trunk card status" (page 267). If anycards show "not responding", verify the following:a. the ELAN network interface cable connection to the ELAN subnetb. the TLAN network interface cable connection to the TLAN subnetc. the ELAN MAC addresses that were entered previously on theConfiguration tab of the Node Properties, while adding the IPTrunk 3.01 (and later) node on TM 3.1d. IP addressesNortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.