374 OA and M using the ITG shell CLI and overlaysWhen prompted to login, enter the default username and passwordas:VxWorks login: itgadminPassword: itgadminITG>6 If this card is Leader 0, use the setLeader command:ITG> setLeader xxx.xxx.xxx.xxx, yyy.yyy.yyy.yyy,zzz.zzz.zzz.zzz and press Enter.where• xxx.xxx.xxx.xxx is the IP address of the ELAN network interfaceon Leader 0.• yyy.yyy.yyy.yyy is the gateway IP address for the ELAN networkinterface on Leader 0. If the TM 3.1 PC is connected directly tothe LAN and there is no ELAN network interface gateway, thenthe gateway IP address is "0.0.0.0".• zzz.zzz.zzz.zzz is the subnet mask for the ELAN networkinterface on Leader 0.7 Do not leave the card with the default user name and password."Change the default ITG shell password to maintain access security"(page 371)8 Configure all the IP trunk cards in the same node with the samepassword. Repeat this procedure for other cards in the IP Trunk3.01 (and later) node.—End—Download the ITG operational measurements through the ITG shellThe ITG operational measurements file contains counts of incoming andoutgoing calls, call attempts, calls completed, and total holding time forvoice and fax calls. To download this file from the TM 3.1 PC to the IP trunkcard, at the ITG shell prompt, type the following:currOMFilePut <hostname, username, password, directory path,filename> for the current fileorprevOMFilePut <hostname, username, password, directory path,filename> for the previous file.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.
