IP trunk card self-tests 407Table 65Operational Measurement commandCommand DescriptionresetOM This command returns all Operational Measurement parameterscollected since last log dump, including:• outgoing calls tried• outgoing calls completed• incoming calls tried• total voice time• total fax time• outgoing packets discarded• incoming packets out–of–sequence• average packet delay• average packet loss• number of Fallback-to-PSTN callsTable 66DCHIP-only commandsCommand DescriptionDCHenable Enable the DCH application on the card.DCHdisable Disable the DCH application on the card.DCHestablish Establish the DCH link when it is in release mode.DCHrelease Release the DCH link when it is in establish mode.DCHstatus Display the DCH application state.DCHmenu This command allows the user to access the UIPC Debug Menu.Once in passthru mode, the user has to "exit" the Debug Menu,before issuing any other ITG Shell Commands.dchipResTableShow Available from ITG shell. Show the Followers associated witha DCHIP.IP trunk card self-testsDuring power-up, the IP trunk card performs diagnostic tests to checkcorrect operation. Use the faceplate RS-232 port on the IP trunk card tomonitor these tests. IP Trunk 3.01 (and later) sends messages indicatingthe completion of each phase of testing and any detected faults, to this port.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.
