382 OA and M using the ITG shell CLI and overlays3 Press Enter. Monitor the status of the software upgrade and checkthat the upgrade correctly finishes. Observe any error messagesthat indicate problems with parameters or syntax.4 When the new software has downloaded into the flash ROM device,reboot the IP trunk card to use it. Use the cardReset command orpress the reset button on the IP trunk card faceplate.—End—Backup and restore from the CLIUse Procedure 67 "Backing up from the CLI" (page 382) and Procedure68 "Restoring from the CLI" (page 383) to backup and restore when thepreferred method, using the TM 3.1 PC, is not available. This wholeprocedure must be performed when a configuration file has been changed.First, use the ’Put’ commands to back up the IP trunk card configurationfiles. Restore the files later using the "Get" commands.However, the "DPAddrTGet" file can be used to restore the dialing plan filefrom another IP trunk card in the same node.Backup from the CLIFollow the steps in Procedure 67 "Backing up from the CLI" (page 382) toperform a backup from the CLI.Procedure 67Backing up from the CLIStep Action1 Identify an appropriate FTP host and obtain the IP address, the username, the password, and a directory path on the host.2 Log in to the ITG shell of the Leader 0 IP trunk card of the IP Trunk3.01 (and later) node.3 Use the BootPFilePut command with the appropriate parameters,to backup the Node Properties file to the FTP host.4 Use the DPAddrPut command with the appropriate parameters, tobackup the dialing plan file to the FTP host.5 For each IP trunk card, log in to the ITG shell and use theconfigFilePut command to backup the card properties files.Each file must be named to identify the card it goes with.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.
