398 MaintenanceCommand FunctionLDIC l s c u List the number of days since the last incoming call onthe indicated trunk, where:l = loop, s = shelf, c = card, and u = unit.STAT l s c Print the system software status of the indicated IPtrunk card, where:l = loop, s = shelf, and c = card.RSET l s c u Reset thresholds for the indicated trunk, where:l = loop, s = shelf, c = card, and u = unit.For Meridian 1 PBX 11C Cabinet, Meridian 1 PBX 11C Chassis, CS 1000M Cabinet, and CS 1000MChassis, the TN address < l s c > should be replaced by < s c > and the < l s c u > addressreplaced by < s c u >.Information equivalent to that provided by the STAT command can beaccessed from the command line on the card.Identify IP Trunk 3.01 (and later) trunk routes and IP trunk cardsin the systemIn LD 16, the Route Data Block, use the "DES" prompt to identify the IPTelephony Gateway route.IP trunk card ELAN network interface MAC address and IPaddressIn LD 14, use the "DES" prompt to identify the ELAN network interfaceMAC address and IP address.Print the IP Trunk 3.01 (and later) trunk route and trunkdesignatorsIn LD 21, enter the "LTM" (List Trunk Members) in response to the "REQ"prompt to list the IP Trunk 3.01 (and later) route designator’s and theindividual IP Trunk 3.01 (and later) trunk designators’ MAC addressesand IP addresses. When cards are added, deleted, or changed, the trunkdesignators must be updated.TM 3.1 maintenance commandsWhen changing DSP parameters in TM 3.1, disable the IP trunk card’s portsbefore downloading the new parameters. Modifications to node parametersrequire the affected cards to be rebooted. A dialing plan can be modifiedwithout rebooting or disabling the cards.Multi-purpose Serial Data Link (MSDL) commandsAll system MSDL commands are supported. Use LD 96 to enter MSDLcommands. Table 58 "MSDL commands" (page 399) lists some of the moreimportant commands.Nortel Communication Server 1000IP Trunk FundamentalsNN43001-563 02.01 StandardRelease 5.5 21 December 2007Copyright © 2007, Nortel Networks.