(6) Changing an Id-code NamePerform the following procedure when you want to change aregistered id-code name.* You will need to enter the registered management password whenyou want to change an id-code name. (Refer to “Registering theManagement Password”, page 6-11.)* If you want to cancel the procedure part way through, press theReset key. The operation panel will return to the initial mode settings.1. Perform steps 1 - 6 of “(5) Registering Access Codes”, page 4-56.2. Use the cursor up or the cursor down key to select the accesscode that corresponds to the id-code name to be changed.3. Press the Enter key.4. Enter the desired id-code name.(Refer to “Entering characters”, page 1-28.)* The id-code name can be up to 32 characters in length.* Press the Stop/Clear key to clear the currently displayed namefrom the message display and enter the name from thebeginning.5. Press the Enter key.Registration of the new id-code name is complete.> If you want to continue changing other id-code names, repeatsteps 2 - 5.> If you are finished changing id-code names, press the Resetkey. The operation panel will return to the initial mode settings.(7) Deleting Access CodesPerform the following procedure when you want to delete aregistered access code.* You will need to enter the registered management password whenyou want to delete an access code. (Refer to “Registering theManagement Password”, page 6-11.)* If you want to cancel the procedure part way through, press theReset key. The operation panel will return to the initial mode settings.1. Perform steps 1 - 6 of “(5) Registering Access Codes”, page 4-56.2. Use the cursor up or the cursor down key to select the accesscode to be deleted.3. Press the Stop/Clear key.* If you want to cancel the deletion procedure, simply press theStop/Clear key again.4. Press the Enter key. The selected access code will be deleted.> If you want to continue deleting other access codes, repeatsteps 2 - 4.> If you are finished deleting access codes, press the Reset key.The operation panel will return to the initial mode settings.4-58Section 4 Other Features of this FaxAccess code:#01:#02:ê #03:3363:SKL-G#03:SKL-GID-code name#03:PDL-GID-code nameAccess code:#01:#02:ê #03:3363:PDL-GAccess code:#01:#02:ê #03:3363:PDL-GAccess code:#03Press ENTER key.DeleteAccess code:#01:#02:ê #03:01-DEC-1999 12:00Set original
