6-93. Press the Enter key.4. Use the cursor up or the cursor down key to select the desiredpaper feed mode.* The asterisk (*) in the message display indicates the currentsetting.> If you selected “Auto selection”…Proceed to step 5.> If you selected “Fixed size”…1 Press the Enter key.2 Use the cursor up or the cursor down key to select the desiredpaper size.> If you selected “Fixed cassette”…1 Press the Enter key.2 Use the cursor up or the cursor down key to select the desireddrawer.5. Press the Enter key.The setting for Paper Feed Selection is complete.* If you are finished making settings, press the Reset key.The operation panel will return to the initial mode settings.Section 6 Various Settings and Registration in this FaxPaper feed sel:ê*Auto selectionFixed size PFixed cassette PFixed cassette:ê Top drawer2nd drawer3rd drawerSet fax:Reception mode:Fax receptRX date/time :Offê Paper feed sel:2nd drawerFixed size:ê A3B4A4Turning Remote Diagnosis ON/OFFEspecially if trouble occurs in this fax in which it is necessary to callfor service, it is possible for our service centre computer to accessthe fax directly over the telephone line and check its status and otherinformation about the trouble.* To use Remote Diagnosis, it is necessary to enter into a contractwith an authorized service centre in advance and also to register apredetermined Remote Test ID in advance.(Refer to “Registering the Remote test ID”.)For further information, contact your service representative, anauthorized service centre or the place of purchase.* If you want to cancel the procedure part way through, press theReset key. The operation panel will return to the initial mode settings.1. Press the CONFIGURE key.2. Use the cursor up or the cursor down key to select “Remote diagn.”.3. Press the Enter key.4. Use the cursor up or the cursor down key to select whether to turnRemote Diagnosis ON or OFF.* The asterisk (*) in the message display indicates the currentsetting.5. Press the Enter key. The setting for Remote Diagnosis is complete.* If you are finished making settings, press the Reset key.The operation panel will return to the initial mode settings.Remote diagn.:ê On*OffSet fax:2-up RX :OffManagement :Offê Remote diagn. :OffSet fax:2-up RX :OffManagement :Offê Remote diagn. :On01-DEC-1999 12:00Set originalSet fax:Endê TTI :Outside p.Print report P
