be sent on the selected days during the programmed time frames. Notifications can also be sent"continuously", meaning a notification will be sent whenever a new message is received, 24 hours a day.Conditions• Notifications can be sent for either all messages or for urgent messages only, depending on whether the"Only Urgent Messages" setting is enabled. When it is enabled, notifications are sent (according to thenotification schedule, if programmed) only when urgent messages have been left in the subscriber’smailbox.• A maximum of 3 devices can be programmed by the System Administrator or subscriber for use with thisfeature. When the Unified Messaging system calls a device and the call is not answered, the system willtry to call the device again. The number of retries and the delay time between retries can be programmedby the System Administrator. The lowest numbered device is called first. If the first device cannot be called,the second (then third) device will be called.PC Programming Manual References20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Notification Parameters→ Telephone Device→ Telephone Device—Device No. 1, 2, 3—Only Urgent Messages→ Telephone Device—Device No. 1, 2, 3—Dial Number [0-9 * # T X , ;]→ Telephone Device—Device No. 1, 2, 3—No. of Retries→ Telephone Device—Device No. 1, 2, 3—Busy Delay Time (min)→ Telephone Device—Device No. 1, 2, 3—No Answer Delay Time (min)→ Telephone Device—Device No. 1, 2, 3—Use Mode→ Telephone Device—Device Notification Timer—Device Start Delay Time (0-120 min)→ Telephone Device—Device Notification Timer—Device Interval Time between Device 1, 2, 3 and NextDevice24.4 UM Configuration—[5-4] System Parameters—Parameters—Dialling Parameters/MSW NotificationUser Manual ReferencesSubscriber Operation1.8.6 Other Features— Message Waiting NotificationManager Operation2.2.2 Message Manager Features— Setting Up Message Waiting Notification3.2.1.31 Multilingual ServiceDescriptionAllows a maximum of 8 languages to be used for system prompts. The System Administrator can select 5languages for the multilingual selection menu, and assign a key for each language in the menu. Callers canselect the desired language by pressing the assigned key. The language used for system prompts heard bysubscribers is determined by Class of Service (COS).PC Programming Manual References24.4 UM Configuration—[5-4] System Parameters—Parameters—Prompt SettingFeature Guide 3473.2.1 System Features