Chapter 4 Settings — [ADVANCED MENU] menu106 - ENGLISH[EDGE BLENDING]The edge blending function allows multiple projector images to be seamlessly overlapped by using the inclinationof the brightness at the overlapped area.1) Press as to select [EDGE BLENDING].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Sets the edge blending function to off.[ON] Use the setting value preset in the projector for the inclination of the edge blending area.[USER] Use the user‑setting value for the inclination of the edge blending area. (Configuration/registrationrequires separate software. Consult your dealer.)f When anything other than [OFF] is selected, proceed to Step 3).3) Press the button.f The [EDGE BLENDING] screen is displayed.4) Press as to specify the location to be corrected.f When joining at top: Set [UPPER] to [ON]f When joining at bottom: Set [LOWER] to [ON]f When joining at left: Set [LEFT] to [ON]f When joining at right: Set [RIGHT] to [ON]5) Press qw to switch to [ON].6) Press as to select [START] or [WIDTH].7) Press qw to adjust the starting position or correction width.8) Press as to select [MARKER].9) Press qw to switch to [ON].f A marker for image position adjustment is displayed. The position where the red and green lines overlap forthe projectors to be joined will be the optimal point. Make sure to set the correction width for the projectorsto be joined with the same value. Optimal joining is not possible with projectors that have differentcorrection widths.The optimal point is the point at which these lines overlap.Green lineRed line10) Press as to select [BRIGHTNESS ADJUST].11) Press the button.f The [BRIGHTNESS ADJUST] screen is displayed.f By setting [AUTO TESTPATTERN] to [ON] on the [EDGE BLENDING] screen, the black test pattern isdisplayed when you enter the [BRIGHTNESS ADJUST] screen.12) Press as to select [NON-OVERLAPPED BLACK LEVEL].13) Press the button.f The [NON-OVERLAPPED BLACK LEVEL] screen is displayed.f [RED], [GREEN], and [BLUE] can be adjusted individually if [INTERLOCKED] is set to [OFF].
