Chapter 3 Basic Operations — ProjectingENGLISH - 69ProjectingCheck the projection lens attachment (x page 49), external device connection (x page 52), and power cordconnection (x page 59), and then switch on the power (x page 60) to start projecting. Select the video forprojection, and adjust appearance of the projected image.Selecting the input signalThe input of the image to project can be switched. Method to switch the input is as follows.f Press the input selection button and directly specify the input of the image to project.f Display the input selection screen and select the input of the image to project from the list.Remote control Control panelSwitching the input directlyThe input of the image for projection can be switched by directly specifying it with the input selection button on theremote control or the control panel.1) Press the input selection button (, , , , or ).Switches the input to RGB1.The image of the signal input to the terminal (R /VIDEO>, , B/C>, HD>, ) is projected. Switches the input to RGB2.The image of the signal input to the terminal is projected. Switches the input to DIGITAL LINK.The image of the signal input to the terminal is projected. Switches the input to DVI-D.The image of the signal input to the terminal is projected. Switches the input to HDMI.The image of the signal input to the terminal is projected.Switches the input to SDI1 or SDI2.The image of the signal input to the terminal or the terminal is projected.Switches to the other input when one input has already been selected.Input selection can be fixed to SDI1 or SDI2 using the [SECURITY] menu → [CONTROL DEVICESETUP].Attentionf Images may not be projected properly depending on the external device, or the Blu-ray disc or DVD disc, to be played back.Set the [PICTURE] menu → [SYSTEM SELECTOR]. When the SDI signal is input, set the [DISPLAY OPTION] menu → [SDI IN].f Confirm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →[ASPECT].Notef When the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the LAN> terminal, the input on the DIGITAL LINK output supported device changes each time the button is pressed. The inputcan also be changed using the RS-232C control command.For twisted-pair-cable transmitters of other manufacturers, switch the input on the projector to DIGITAL LINK, and then switch the input onthe twisted-pair-cable transmitter.
