Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 61f If the power was turned off at the previous use by pressing the side of the switch or by using the breaker directlywhile projecting, the power indicator lights up in green and an image is projected after a while when the poweris turned on by pressing the side of the switch or by turning the breaker on with the power plug connected to theoutlet. This applies only when the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY].f The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.When the initial setting screen is displayedWhen the projector is switched on for the first time after purchase, as well as when the [PROJECTOR SETUP]menu → [INITIALIZE] → [ALL USER DATA] is executed, the focus adjustment screen is displayed after projectionstarts, and then the [INITIAL SETTING] screen is displayed. Set them according to the circumstances.In other occasions, you can change the settings by menu operations.If you press the [INITIAL SETTING] screen is displayed, you can go back to theprevious screen.Focus adjustmentAdjust the focus to display the menu screen clearly.You may also need to adjust the zoom and lens shift.Refer to “Adjusting the focus, zoom, and lens shift” (x page 70) for details.1) Press asqw to adjust the focus.52FOCUS POSITIONLENSFOCUSADJUST2) Press the Initial setting (display language)Select the language to show on the screen.After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.1) Press as to select the display language.ENTER1/7Please select DISPLAY LANGUAGE.INITIAL SETTINGSELECTSET2) Press the button to proceed to the initial setting.
