Chapter 4 Settings — [DISPLAY OPTION] menu126 - ENGLISH3) Press as to select [EDID MODE].4) Press the button.f The [DIGITAL LINK EDID MODE] screen is displayed.5) Press qw to switch [EDID MODE].f The items will switch each time you press the button.[DEFAULT] Standard setting.[SCREEN FIT] Changes EDID data according to the [SCREEN FORMAT] setting.[USER] Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items to EDID.f When [DEFAULT] or [SCREEN FIT] is selected, proceed to Step 10).6) Press the button.f The [RESOLUTION] screen is displayed.7) Press asqw to select [RESOLUTION].f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p],[1440x900p], [1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].8) Press the button.f The [VERTICAL SCAN FREQUENCY] screen is displayed.9) Press qw to select [VERTICAL SCAN FREQUENCY].f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].g [1920x1080p], [1920x1080i]10) Press the button.f The confirmation screen is displayed.11) Press qw to select [OK], and press the button.Notef The setting details are displayed in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] of [EDID STATUS].f The resolution and vertical scanning frequency settings may also be required on your computer or video device.f After configuring settings, your computer or video device or the projector may be required to be turned off and on.f A signal may not be output with the resolution and vertical scanning frequency that have been set, depending on your computer or videodevice.[SDI IN]Set this function in accordance with the signal input to the / terminals.Setting [SDI LINK] in [SDI IN]1) Press as to select [SDI IN].2) Press the button.f The [SDI IN] screen is displayed.3) Press as to select [SDI LINK].4) Press the button.f The [SDI LINK] screen is displayed.5) Press as to select the setting.[SINGLE] Sets the SDI1 input and the SDI2 input to single link.[DUAL] Sets the SDI1 input and the SDI2 input to dual link.[AUTO]Automatically selects the single link or the dual link.The single link or dual link is automatically distinguished by reading the payload ID attached to eachinput signal. Single link will be selected when a payload ID is not added to the input signal.
