| 
Chapter 7 Appendix — Technical information234 - ENGLISH3) Press the button on the control panel.f It will go into an IP address setting mode (where the self‑diagnosis display is blinking in 0.5 secondintervals).f It will not go into the IP address setting mode even if the button on the remote control is pressed.4) Press the button on the remote control or control panel.f [DHCP] is set to [ON].f The setting is reflected to the [NETWORK] menu → [NETWORK SETUP] → [DHCP].f The IP address setting mode is canceled when the button is pressed, and the setting isdisplayed in the self-diagnosis display for approximately two seconds.“IPo”Display endNotef The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.f The IP address will be set to the following factory default setting when the button on the remote control is press while in the IPaddress setting mode.[DHCP] OFF[IP ADDRESS] 192.168.0.8Specifying the IP addressEnter the IP address when there is no DHCP server in the network where the projector is to be connected.1) Press the side of the switch to turn on the power.f The power indicator lights in red, and the projector enters the standby mode.2) Press and hold the button on the remote control for three seconds or more.f Currently set IP address is displayed in the self-diagnosis display at the side of the projector.3) Press the button on the control panel.f It will go into an IP address setting mode (where the self‑diagnosis display is blinking in 0.5 secondintervals).f It will not go into the IP address setting mode even if the button on the remote control is pressed.4) Press asqw to enter the IP address.f Press qw to switch the display of the IP address in the self-diagnosis display. Press qw to display theaddress to change, and then press as or the number (<0> ‑ <9>) buttons to set the address.f Once all the addresses are entered, proceed to Step 5).5) Press the button on the remote control or control panel.f [IP ADDRESS] is set to the entered IP address.f The setting is reflected to the [NETWORK] menu → [NETWORK SETUP] → [IP ADDRESS].f The IP address setting mode is canceled when the button is pressed, and the settings aredisplayed in the self-diagnosis display in two second intervals as follows. Next display is an example when[IP ADDRESS] is set to 192.168.0.10.“192” “168” “000” “010”Display endNotef The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.f The IP address will be set to the following factory default setting when the button on the remote control is press while in the IPaddress setting mode.[DHCP] OFF[IP ADDRESS] 192.168.0.8 |
