Chapter 7 Appendix — Technical informationENGLISH - 233g When the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO]f Only confirmation of the IP address is possible in following case. Setting is not possible.g When the [NETWORK] menu → [Art‑Net SETUP] is set to [ON(2.X.X.X)], [ON(10.X.X.X)]f Setting and confirming of the subnet mask and default gateway are not possible. They are preset as follows as the factory default settings. Ifit is necessary to change from the current settings, turn on the projector, and set the [NETWORK] menu → [NETWORK SETUP].[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.0.1Confirming the IP address1) Press the side of the switch to turn on the power.f The power indicator lights in red, and the projector enters the standby mode.2) Press and hold the button on the remote control for three seconds or more.f Currently set IP address is displayed in the self-diagnosis display at the side of the projector.f For details on displaying of the IP address in the self-diagnosis display, refer to “IP address displaytransition” (x page 233).Notef [IP ADDRESS] can be confirmed in the [NETWORK] menu → [NETWORK STATUS] when the projector is turned on.IP address display transitionThe indication in the self-diagnosis display at the side of the projector will transition as follows in two secondintervals when the IP address is displayed.r When [DHCP] is set to [OFF]This is an example when the [NETWORK] menu → [NETWORK SETUP] → [DHCP] is set to [OFF], and [IPADDRESS] is set to 192.168.0.8.“192” “168” “000” “008”Display end“IP”r When [DHCP] is set to [ON]This is an example when the [NETWORK] menu → [NETWORK SETUP] → [DHCP] is set to [ON], and [IPADDRESS] is set to 192.168.0.8.“IPo” “192” “168” “000” “008”Display endr When the IP address cannot be acquiredThis is when the IP address cannot be acquired from the DHCP server.“IPo” “---”Display endSetting the IP addressWhen using the DHCP serverIP address can be acquired automatically when there is a DHCP server in the network where the projector is to beconnected.1) Press the side of the switch to turn on the power.f The power indicator lights in red, and the projector enters the standby mode.2) Press and hold the button on the remote control for three seconds or more.f Currently set IP address is displayed in the self-diagnosis display at the side of the projector.
