Chapter 2 Getting Started — ConnectingENGLISH - 53 terminal pin assignments and signal namesOutside view Pin No. Signal name Pin No. Signal name(17)(24)(16) (9)(1)(8)(1) T.M.D.S data 2- (13) ―(2) T.M.D.S data 2+ (14) +5 V(3) T.M.D.S data 2/4 shield (15) GND(4) ― (16) Hot plug detection(5) ― (17) T.M.D.S data 0 -(6) DDC clock (18) T.M.D.S data 0+(7) DDC data (19) T.M.D.S data 0/5 shield(8) ― (20) ―(9) T.M.D.S data 1 - (21) ―(10) T.M.D.S data 1+ (22) T.M.D.S clock shield(11) T.M.D.S data 1/3 shield (23) T.M.D.S clock+(12) ― (24) T.M.D.S clock-Connecting example: AV equipmentFor // terminalsBlu-ray disc playerVCR (with built-in TBC)VCR (with built-in TBC)DVD player with HDMI terminal (HDCP)Attentionf Always use one of the following when connecting a VCR.g A VCR with built‑in time base corrector (TBC)g A time base corrector (TBC) between the projector and the VCRf If nonstandard burst signals are connected, the image may be distorted. In such a case, connect the time base corrector (TBC) between theprojector and the external devices.Notef Switching of the setting in the [DISPLAY OPTION] menu → [DVI-D IN] → [EDID SELECT] may be required depending on the connectedexternal device when DVI-D is input.f The terminal can be connected to HDMI- or DVI-D-compliant devices. However, images may not appear or may not bedisplayed properly on some devices.f For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMIstandards is used, images may be interrupted or may not be displayed.f The terminal of the projector can be connected to an external device equipped with a DVI-D terminal using an HDMI/DVIconversion cable. However, this may not function properly for some external devices, and images may not be displayed.f The projector does not support VIERA Link (HDMI).f It is necessary to switch the setting in the [DISPLAY OPTION] menu → [RGB IN] → [RGB1 INPUT SETTING] (x page 121) when inputtinga video signal and the Y/C signal.
