Panasonic PT-RZ21K Operating Instructions Manual

Also see for PT-RS20K: Command list Operating instructions Operating instructions

Contents

Chapter 3 Basic Operations — Projecting70 - ENGLISHf Set the [DISPLAY OPTION] menu → [RGB IN] → [RGB1 INPUT SETTING] in accordance with the signal input to the terminal.Switching the input by displaying the input selection screenThe input of the image for projection can be selected by displaying the input selection screen.1) Press the button on the remote control.f The input selection screen is displayed.INPUT SELECTRGB1RGB2DVI-DHDMIDIGITAL LINKSDI1SDI2SELECTSETENTER2) Press the button again.f The input will switch each time you press the button.Notef Input can be switched by pressing as to select the input of the image for projection and pressing the button while the inputselection screen is displayed.f The [P IN P MODE] screen is displayed when the button is pressed while in the P IN P. (x page 171)f If the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, the inputselection menu for the DIGITAL LINK output supported device is displayed when the button is pressed while the DIGITAL LINKinput is selected in the input selection screen.f If the optional DIGITAL LINK output supported device (Model No.: ET‑YFB100G, ET‑YFB200G) is connected to the projector, the DIGITALLINK logo and the input name selected in the DIGITAL LINK output supported device are displayed in the display section of the [DIGITALLINK] in the input selection screen.f Set the [DISPLAY OPTION] menu → [RGB IN] → [RGB1 INPUT SETTING] in accordance with the signal input to the terminal.Adjusting the focus, zoom, and lens shiftAdjust the focus, zoom, and lens shift if the image projected to the screen or its position is shifted even if theprojector and the screen are set up in the correct positions.This section describes the adjustment method when anything other than the Fixed‑focus Lens (Model No.:ET‑D75LE95, ET‑D75LE90) is used. When the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) isused, refer to “Adjusting the focus when the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) is used”(x page 71).Using the control panel1) Press the button on the control panel.f Pressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM], and [SHIFT].2) Select each item and press asqw to adjust it.Using the remote control1) Press the lens buttons (, , ) on the remote control.f Pressing the button: Adjusts the focus (adjustment of the lens focus position).f Pressing the button: Adjusts the zoom (adjustment of the lens zoom position).f Pressing the button: Adjusts the lens shift (vertical position and horizontal position of the lens).2) Select each item and press asqw to adjust it.