Panasonic PT-VW355N Operating Instructions Manual

Also see for PT-VW355N: Operating instructions

Contents

Indicator status StatusGreenLit Projecting.BlinkingThe power is on and the lamp is not working. The [PROJECTOR SETUP] menu x [ECOMANAGEMENT] x [POWER MANAGEMENT] is set to [READY].*3The lamp starts work. The projector will project image after a while.* 4*1: The indicator will light as the following order:2.75 seconds (light) → 0.25 seconds (off) → 0.75 seconds (light) → 0.25 seconds (off)*2: The indicator will light as the following order:2.75 seconds (light) → 0.25 seconds (off)*3: The indicator will light as the following order:2.0 seconds (light) → 2.0 seconds (off)*4: The indicator will light as the following order:0.5 seconds (light) → 0.5 seconds (off)Powering On the ProjectorBefore switching on the projector, make sure all the other devices are correctly connected (x page 36) and remove the lenscap.1) Connect the power cord to the projector body.2) Connect the power plug to an outlet.f The power indicator lights or blinks, and the projector will enter the standby mode.3) Press the power <v/b> button on the control panel or the power on <b> button on the remote control.f The power indicator lights in green and the image is soon projected on the screen.Attentionf Be sure to remove the lens cap before starting projection.Notef If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], it may take approx. 10seconds longer before the projector starts projecting after the power is turned on, compared with when [NORMAL] is set.When the initial setting screen is displayedWhen the projector is switched on for the first time after purchase as well as when [INITIALIZE ALL] in the [PROJECTORSETUP] menu is executed, then the initial setting screen is displayed. Set them in accordance with circumstances.In other occasions, you can change the settings by menu operations.Initial setting (display language)Select the language to show on the screen.After completed the initial setting, you can change the display language from the [LANGUAGE] menu.1) Press asqw to select the display language.42 - ENGLISHChapter 3 Basic Operations - Powering on/off