[PROJECTOR ID]The projector has an ID number setting function that can be used when multiple projectors are used side by side to enablesimultaneous control or individual control via a single remote control.1) Press as to select [PROJECTOR ID].2) Press the button.f The [PROJECTOR ID] screen is displayed.3) Press as to select a projector ID.f Select one from [ALL], and [1] to [6].[ALL] Select when controlling projectors without specifying an ID number.[1] - [6] Select when specifying an ID number to control individual projector.4) Press the button to set it.f [PROJECTOR ID] is set.Notef To specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.f When the ID number is set to [ALL], the projector will operate regardless of the ID number specified during remote control orcomputer control.If multiple projectors are set up side by side with ID set to [ALL], they cannot be controlled separately from the projectorswith other ID numbers.f Refer to “Setting the ID number of the remote control” (x page 54) for how to set the ID number on the remote control.[INITIAL START UP]Set the method of start up when the power cord plugged into the AC outlet.1) Press as to select [INITIAL START UP].2) Press qw to switch the item.f The items will switch each time you press the button.[LAST MEMORY] Starts in the condition that before disconnected the power cord or turn off the breaker.[STANDBY] Starts up in the standby mode.[ON] Starts the projection immediately.[PROJECTION METHOD]Set the projection method in accordance with the installation status of the projector.Change the projection method if the screen display is upside down or inverted.1) Press as to select [PROJECTION METHOD].2) Press qw to switch the projection method.f The items will switch each time you press the button.[FRONT/DESK] Select when installing the projector on the desk, etc., in front of the screen.[FRONT/CEILING] Select when installing the projector in front of the screen with the Ceiling Mount Bracket (optional).[REAR/DESK] Select when installing the projector on the desk, etc. behind the screen (with a translucent screen).[REAR/CEILING] Select when installing the projector behind the screen (with a translucent screen) with the CeilingMount Bracket (optional).[HIGH ALTITUDE MODE]Change the setting according to the altitude in which you use the projector.1) Press as to select [HIGH ALTITUDE MODE].2) Press qw to switch the item.f The items will switch each time you press the button.[OFF] Select when using the projector in the elevation of below 1 400 m (4 593′).[HIGH1] Select when using the projector in the elevation of above 1 400 m (4 593′) and below 2 000 m(6 562′).78 - ENGLISHChapter 4 Settings - [PROJECTOR SETUP] menu