Notef Wireless LAN and wired LAN cannot be used in the same segment.f When multiple devices are connected, a unique IP ADDRESS must be allocated to each device.f SSID has to be entered in alphanumeric letters.f You cannot set “any” or “ANY” for SSID.f The projector settings are not required when MIRRORING is connected. For details about MIRRORING, please refer to"About MIRRORING" (x page 123).f The following settings are set before the projector leaves the factory.[SIMPLE][KEY] proj + The last 4 digits of the network ID[NORMAL] → [M-DIRECT][IP ADDRESS] 192.168.12.100[SUBNET MASK] 255.255.255.0[SSID] M-DIRECT + The last 4 digits of the network ID[CHANNEL] 1[KEY] The same string as the SSID[NORMAL] → [USER1] ~ [USER3][SSID] Panasonic Projector[DHCP] OFF[IP ADDRESS] 192.168.11.100[SUBNET MASK] 255.255.255.0[DEFAULT GATEWAY] 192.168.11.1[AUTHENTICATION] OPEN[ENCRYPTION] NONE[DNS1] / [DNS2] NONEComputer settings1) Turn on the computer.2) Make the network setting according to your system administrator.f If you select [M-DIRECT] in [WIRELESS LAN], the IP address will automatically be acquired.f If you select [USER1] ~ [USER3] in [WIRELESS LAN], then make the network settings for the computer and theprojector according to your system administrator.3) Connect the computer to the network that has been set for the projectors.f If you use a Windows computer, click on the task tray (bottom right of the Windows screen), then select the samename as the SSID that has been set in the projector when you select [M-DIRECT] in [WIRELESS LAN], or select thesame name as the SSID that is used in current access point when you select [USER1] ~ [USER3] in [WIRELESS LAN].If you use a Mac computer, click on the menu bar (top right of the Mac screen), then select the same name as theSSID that has been set in the projector.f When you select default settings of [M-DIRECT] for [WIRELESS LAN] in the network menu, the SSID is [M-DIRECT +The last 4 digits of the network ID].Notef If you use any wireless LAN connection utility that meets the OS standard, follow the operation instruction of the utility toconnect it.Accessing from the web browser1) Start up the web browser on the computer.2) Enter the IP address set on the projector into the URL entry field of the web browser.3) Enter the user name and the password.f The factory default setting of the user name is user1 (user rights)/admin1 (administrator rights) and the password ispanasonic (lower case).ENGLISH - 99Chapter 4 Settings - [NETWORK/USB] menu