6)Pressqwto adjust the level.OperationAdjustmentRangePress thewbutton.Turns up the MIC mixing gain.0 ~ 63Press theqbutton.Turns down the MIC mixing gain.NotefWhen [OFF] is selected in MIC function, the MIC GAIN function is not available.fIf the MIC function is set to [ON] when connecting audio signals to the output suddenly depending on the setting value of [MIC GAIN].fWhen [MIC] is set to [ON], no signal is input, AV MUTE function is on, FREEZE function is on or the POWERMANAGEMENT function is working, the audio of MIC will be output.[EASY SETTING]You can set the operation when press the button on the control panel.1)Pressasto select [EASY SETTING].2)Press the button.fThe [EASY SETTING] screen is displayed.3)Pressasto select [FOCUS ASSIST], [SCREEN FIT] or [COLORBOARD].[FOCUS ASSIST]The level of focus adjustment is displayed in the color and length of the bar. It is supported themanual adjustment through rotating the focus ring.[SCREEN FIT]If it detects a screen frame, the projected image is corrected to fit the screen frame automatically.If it does not detect a screen frame, the KEYSTONE starts to work automatically.[COLORBOARD]The color values will change automatically to reach the optimal color except for the white screen.4)Pressqwto switch the item.fThe items will switch each time you press the button.[FOCUS ASSIST]This function is enabled when it is set to [ON]. This function is disabled when it is set to [OFF].[SCREEN FIT]The image will be displayed in full screen when it is set to [FULL]. The projected image willmaintain the aspect ratio which is input when it is set to [ORIGINAL]. This function is disabledwhen it is set to [OFF].[COLORBOARD]This function is enabled when it is set to [ON]. This function is disabled when it is set to [OFF].NotefFor details about EASY SETTING, refer to "Adjusting the projected image via EASY SETTING function" (xpage47).fIf all items are set to [OFF], press the button and then [KEY NOT APPLICABLE] massage willbe displayed on the screen.[TEST PATTERN]Displays the test pattern built-in to the projector.Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal beforeperforming various adjustments.1)Pressasto select [TEST PATTERN].2)Press the button.fThe test pattern with the [PATTERN CHANGE] individual adjustment screen is displayed.3)Pressqwto switch the item.fThe items will switch each time you press the button.All white → Color bars → White cross on the black background → Black cross on the white background → Cross hatch→ All white →...fWhen you press the [PROJECT SETUP].NotefThe initial setting is All white. The initial screen is Cross hatch if you have assigned it to the button.[FILTER COUNTER]This function is used to reset the filter use time and set the notification display.ENGLISH-83Chapter 4Settings - [PROJECTOR SETUP] menu