Samsung OfficeServ 500 User Instruction

Also see for OFFICESERV 500 Series: Service manual System administration guide Quick setup guide Quick setup guide Quick setup guide

Contents

>1.SYSTEM EASY WIZARD2.SYSTEM INFORMATION3.NETWORK SETUP4.LOAD & UPGRADE SETUP5.SYSTEM SERVER SETUP6.FACTORY RESET8ASSEMBLING YOUR KEYSET• Place the keyset face down on a flat surface.• Insert notched ends of the support bracket into the channels located in theupper section of the bottom panel. Push towards the top of the keyset to lockin.• Plug the handset cord into the jack marked with the symbol.• Route the handset cord out the RIGHT side of the keyset as you look at it facedown.• Plug an eight-conductor ethernet cable, from the wall, into the jack markedLAN on the back of the keyset. (Connect the ITP keyset to any port on the localnetwork).• If your ITP will share LAN connection with a PC, plug an eight-conductor eth-ernet cable, from the PC, into the jack marked PC on the back of the keyset.• Plug the power connector, from the power adapter provided, into the powerjack on the back of the keyset. The power adapter is not required if the ITP isconnected to a LAN connection that provides power over the ethernet. TheITP-5121D supports the power over ethernet feature when it is connected toa IEEE 802.3af compliant LAN switch or power injector port.IMPORTANT NOTE:• Be careful not to connect the Network LAN cable into the PC connector of thephone.• To prevent damaging the keyset, only use the Power Adapter that came withthe 5121D keyset.• This manual assumes that the ITP keysets are connected to a functioning localIP network. The local IP network must be able to communicate with the MCPand MGI card in the OfficeServ 100, OfficeServ 500, or in the OfficeServ 7000Series systems over IP. This is assumed regardless of whether the IP keyset ison a local or remote network.9ITP-5121D SETUPINITIALIZING THE ITP-5121DInitially the ITP-5121D IP keyset will need to be setup to operate within the usersnetwork.The Setup Menu is also used to make changes to the keyset, in the eventthat the system information should change. The option chosen via scroll key willbe highlighted.The station numbers will be automatically set by the OfficeServ 100, OfficeServ500, and the OfficeServ 7000 Series systems once the necessary information hasbeen entered into the IP keyset. Enter ID and password of the server, as describedbelow to register the phone.See your system administrator for specific Network and Server addresses. Theaddresses necessary to set up the ITP-5121D are:• IP Address of the ITP• Network Gateway Address• Subnet Mask• IP Address of System’s MCP• User ID• PasswordTo get to the Set-Up Menu, unplug the power from the ITP-5121D phone orunplug the LAN cable if using Power over Ethernet, press and hold the MENU but-ton while plugging in the power cord or LAN cable if using Power over Ethernetback into the phone. Now release the MENU button.Other items not shown on screen when scrolling down (press down arrow on nav-igation disc).6.FACTORY RESET7.REBOOT