CHAPTER 2. MMC Programming2-72 Samsung Business Communications76B[300] CUSTOMER ON/OFF PER STATIONAllows the following features to be enabled/disabled on a per-station basis.No Option Default Description00 ACCESS DIAL ON Determines whether a user can select a trunk or trunkgroup by dialing its Directory Number(DN). This selectionshould be turned off when using LCR.01 MICROPHONE ON Allows phones to be used in speakerphone mode.02 OFF-HOOK RING ON Will allow a short burst of ring tone to indicate another call.03 SMDR PRINT ON When the station is set for no Trunk Line calls to and fromthis station, the station will not print on SMDR. Thisincludes transferred calls or calls picked up from hold orpark.04 TGR ADV.TONE ON When this feature is set to ON, a warning tone will beheard each time LCR advances to the next route.05 VMAA FORWARD ON This feature selects whether Trunk Line calls can beforwarded to voice mail: ON, permits forward to voicemail; OFF, no forward to voice mail.07 NGT PASSCODE ON When ON, the steps verifying the ring plan passcode willbe added in Ring Plan change.08 INTRCOM SMDR OFF When the station is set to OFF, the station will not printintercom calls on SMDR.09 FWD DELAY USE OFF When ON, calls will overflow to the Forward No Answerdestination when the Forward No Answer timer expireseven when the Forward No Answer feature is notactivated at the called party extension.11 FORWARD OVRD OFF When set to ON and the station calls another stationwhich has forwarding set, the call will not forward.12 RECL TO OPER OFF When the station is set to ON, if the station transfers a calland the destination doesn’t answer, the call will recall tothe operator instead of the station.13 SLT LP OPEN OFF When ON, SLI port receives real disconnect signalinstead of busy or error tone.(VMAA or DATA ports alwaysreceive real disconnect signal.)14 NO COST PRINT OFF When ON, if replacing the handset of a regular phone when nodigit is pressed after hook flash, recall is carried out.15 CID TO SLT OFF When a MIS card is installed and this option is set to ON,the system will provide the CID signal to SLTs.22 NO RCL FLASH OFF When the hook switch is flashed or the flash key ispressed, a recall signal will not be sent to the system.
